Инд. авторы:	Zarko V.E.
Заглавие:	Critical review of the methods to measure the condensed systems transient regression rate
Библ. ссылка:	Zarko V.E. Critical review of the methods to measure the condensed systems transient regression rate // Eurasian Chemico-Technological Journal. - 2018. - Vol.20. - Iss. 1. - P.45-52. - ISSN 1562-3920.
Внешние системы:	DOI: 10.18321/ectj707; РИНЦ: 35532084; SCOPUS: 2-s2.0-85045097316; WoS: 000431857100005;
Реферат:	eng: Accurate knowledge of steady state and transient burning rate of solid fuels and energetic materials is very important for evaluating the performance of different propulsion and/or gas generator systems.The practical demands imply accuracy of available burning rate data on the level of 1% or better and proper temporal resolution. Unfortunately, existing theoretical models do not allow predicting the magnitude of the burning (regression) rate with needed accuracy. Therefore, numerous burning rate measurement methods have been developed by various research groups over the world in the past decades. This paper presents a critical review of existing techniques, including basic physical principles utilized for burning rate determination, an estimate of the temporal and spatial resolutions of the methods as well as their specific merits and limitations. There are known the methods for measuring linear regression rate via high speed cinematography, X-ray radiography and ultrasonic wave reflection technique. Actually, none of those methods could satisfy the practical demands. As an alternative is the microwave reflection method, which potentially possesses high spatial and temporal resolutions and may solve the measurement problem. In addition, there exist methods for measuring transient mass or weight of the burning material. They are based on recording the frequency of oscillations of elastic element with attached specimen or a cantilevered rod with a strain gauge pasted to the base. Practically, these methods could not provide needed accuracy. Much better parameters can be obtained when using the recoil force or microwave resonator techniques. Recommendations for special applications of certain methods are formulated. © 2018 Al-Farabi Kazakh National University.
Ключевые слова:	COMBUSTION; RECOIL-FORCE; PROPELLANT BURNING-RATE;
Издано:	2018
Физ. характеристика:	с.45-52
Цитирование:	1. V.E.Zarko. International Journal of Energetic Materials and Chemical Propulsion 3 (1994) 600-623. DOI: 10.1615/IntJEnergeticMaterialsChemProp.v3.i1-6.590 2. R.Fry, L. DeLuca, G. Gadio, R. Fredericks, R. Strecker, H.-L. Besser, A. Whitehouse, J.-C. Traineau, D. Ribereau, and J. Reynaud. Solid propellant burning rate measurement methods used within the NATO propulsion community. AIAA 2001-3948, 37th AIAA/ASME/ SAE/ASEE JPC Conference and Exhibit, 8-11 July 2001, Salt Lake City, Utah. DOI: 10.2514/6.2001-3948 3. R.M. Salizzoni, W.H. Hsieh, K.K. Kuo, Temperature Sensitivity Measurements and Regression Behavior of a Family of Boron-Based Very High Burning Rate Propellants, in: Combustion of Boron-Based Solid Propellants and Solid Fuels, K.K. Kuo and R. Pein, Eds, CRC Press, Jan. 1993, pp. 438−452. 4. W.H.Hsieh, J.M. Char, K.C. Hsieh, K.K. Kuo, Modeling and measuring of erosive burning of stick propellants, AIAA Paper 1986-1451, AIAA/ ASME/SAE/ASEE 22nd Joint Propulsion Conference, June 16-18, 1986, Huntsville, AL. DOI: 10.2514/6.1986-1451 5. N.Eisenreich, H.P. Kugler, F. Sinn, Propellants, Explosives, Pyrotechnics 12 (1987) 78-80. DOI: 10.1002/prep.19870120304 6. W.A. Wright. Ultrasonic thickness monitoring technique. Aerospace relative technology industry. Washington, DC, 1969, pp.69-72. 7. P. Kuentzmann, J.C. Demarais, and F. Cauty. Ultrasonic measurement of solid ropellant burning rate, La Recherche Aerospatiale, 1979, No 1, 55-72. 8. J.C. Traineau, and P. Kuentzmann, J. Propul. Power 2 (1986) 215-222. DOI: 10.2514/3.22872 9. F.Dijkstra, P.A.O.G. Korting, R.P. van den Berg, Ultrasonic regression rate measurement in solid fuel ramjets, AIAA 90-1963, 9 pp. AIAA/SAE/ ASME/ASEE 26th Joint Propulsion Conference, 1990, Orlando, FL. DOI: 10.2514/6.1990-1963 10. F. Cauty and J.C. Demarais, Ultrasonic Measurement of the Uncured Solid Propellant Burning Rate, 21st International Congress of ICT, Karlsruhe, July 3-6, 1990, 14 pages. 11. S.V. Shelton, A technique for measurement of solid propellant burning rates during rapid pressure transients, 4th ICRPG Combustion Conference, CPIAPubl.162, vol. l, Silver Spring, Md, Dec. 1967, pp.361-372. 12. L.D.Strand, and R.P. McNamara, Progress in Astronautics and Aeronautics 63 (1978) 155-172. DOI: 10.2514/3.57768 13. L.D. Strand, K.R. Magiawala, and R.P. McNamara, J. Spacecraft Rockets 17 (1980) 483-488. DOI: 10.2514/3.57768 14. B.A. Aničin, B. Jojić, D. Blagojević, M. Adžić, V. Milosavljević, Combust. Flame 64 (1986) 309-319. DOI: 10.1016/0010-2180(86)90148-3 15. V.E.Zarko, D.V. Vdovin, V.V. Perov, Combustion, Explosion and Shock Waves 36 (1) (2000) 62-71. DOI: 10.1007/BF02701515 16. V.E. Zarko, V.V. Perov, A.B. Kiskin, Microwaves as a tool for energetic materials characterization. AIAA-02-0190. 40th AIAA Aerospace Sciences Meeting & Exhibit, Aerospace Sciences Meetings, 2002. DOI: 10.2514/6.2002-190 17. O.Ya.Romanov, V.S. Tarkhov, G.G. Shelukhin, Explosion, and Shock Waves 13 (1977) 789-790. DOI: 10.1007/BF00740479 18. V.D.Kochakov, A.E. Averson, S.A. Abrukov, Combustion, Explosion, and Shock Waves 14 (1978) 126-127. DOI: 10.1007/BF00789188 19. T. Brill, Prog. Energy Combust. Sci. 18 (1992) 91-116. DOI: 10.1016/0360-1285(92)90019-W 20. A.V. Khudyakov, G.V. Gorvard, Je. V. Konev, V.F. Miheev, Fizika Goreniya i Vzryva [Combustion, Explosion, and Shock waves] 3 (1967) 462-464 (in Russian). 21. V.F.Mikheev, V.E. Zarko, S.M. Borin, K. Kutsenogii, V. Simonenko, 14th Aerospace Sciences Meeting, Progress in Astronautics and Aeronautics 63 (1976) 173-187. DOI: 10.2514/6.1976-102 22. C.E.Hermance, AIAA Journal 5 (10) (1967) 1775-1778. DOI: 10.2514/3.4303 23. C.F.Yin, C.E. Hermance, 9th Aerospace Sciences Meeting, 1971. DOI: 10.2514/6.1971-173 24. U. Carretta, G. Colombo, C. Guarnieri, Electrostatic method for the instantaneous burning rate measurement in solid materials, Activity Report, CNPM, Milano, Sep. 1992, 44 pp. 25. K. Klager, G.A. Zimmerman, Steady burning rate and affectingf factors: experimental results, In: L.De Luca, E.W. Price, M. Summerfield, Eds., “Nonsteady burning rate and combustion stability of solid propellants”, v.143, Progress in Astronautics and Aeronautics, 1992, Washington, DC, pp. 59-110. 26. V.A.Arkhipov, S.S. Bondarchuk, A.G. Korotkikh. Combustion, Explosion, and Shock Waves 46 (2010) 564-569. DOI: 10.1007/s10573-010-0074-9 27. C.M.Mihlfeith, A.D. Baer, N.W. Ryan, AIAA Journal 10 (1972) 1280-1285. DOI: 10.2514/3.50372 28. V.N. Simonenko, V.E. Zarko. Fizika Goreniya i Vzryva [Combustion, Explosion, and Shock waves] 17 (1981) 129-132 (in Russian). 29. V.E.Zarko, V.N. Simonenko, A.B. Kiskin, Progress in Astronautics and Aeronautics 43 (1992) 363-398. DOI: 10.2514/5.97816008661 59.0363.0398 30. S.F. Son, R.F. Burr, M.Q. Brewster, J. Finlinson, D. Hanson-Parr, Nonsteady burning of solid propellants with an external radiant heat flux: a comparison of models with experiment, AIAA Paper 91-2194, 27th Joint Propulsion Conference, 24-26 June, 1991, Sacramento, CA. See also: S.F. Son. The unsteady combustion of radiant heat flux driven energetic solids,” Ph.D. thesis, Urbana, Illinois (1994). DOI: 10.2514/6.1991-2194 31. A.B.Kiskin, V.N. Simonenko. Combustion, Explosion, and Shock Waves 36 (1) (2000) 48-53. DOI: 10.1007/BF02701513 32. A.B.Kiskin, E. Volpe, L.T. De Luca. Combustion, Explosion, and Shock Waves 36 (1) (2000) 39-47. DOI: 10.1007/BF02701512 33. A.B.Kiskin, E. Volpe, L.T. De Luca. Combustion, Explosion, and Shock Waves 50 (2014) 168-177. DOI: 10.1134/S0010508214020075 34. V.V.Perov, V.E. Zarko, A.S. Zhukov. Combustion, Explosion, and Shock Waves 50 (2014) 739-741. DOI: 10.1134/S0010508214060173